| Error Code | Issue | Troubleshooting Steps |
|---|---|---|
| Error 30 (Flashing all levels, both bars in Base Display) | Communication failure between the controller and other components. | 1. Check all connectors for secure, clean, and proper alignment. 2. Replace components in this order: - Display → test the system. - Battery mount → test again. - Motor wheel → replace as a last step. 3. If the issue persists, a replacement dispatch may be necessary. |
| Error 21 (PAS flashing at level 1 in Base Display) | Motor current abnormality. | 1. Check the motor cable connection to ensure it's secure and undamaged. 2. If the issue persists, further diagnostics or a replacement may be required. |
| Error 25 (PAS flashing at levels 3 and 5 in Base Display) | Brake sensor malfunction. | 1. Disconnect the brake sensors and check if the kit operates normally without them. 2. The error can occur if the kit is turned on while a brake is engaged. To reset: - Turn off the kit. - Ensure that both brakes are fully released. - Turn the kit back on and check if the issue is resolved. 3. If the error persists, inspect the brake sensor installation for misalignment or damage. |
| Error 26 (Undervoltage warning in LED Display) | Low battery voltage. | 1. Charge the battery to resolve the issue. 2. If the warning does not disappear after charging, the battery may be compromised and experiencing undervoltage. In this case, a replacement may be needed. |
| Red Exclamation Mark (!) Symbol in LED Display | This is not an error code. | The symbol briefly appears after turning on the kit and does not indicate a malfunction. No action is needed. |